HP GYM COAT

Water-Based / Ultra Durable Gloss

HP Gym Coat is specifically designed for sports floors combining innovative floor coating technology at a great value. Durable, fast-drying and low VOCs, HP Gym Coat provides high gloss and extended durability. Also, the clear finish lets the natural beauty of the wood shine through.

Features

Ultra durable.

Fast drying/low odor

Dries to a clear film.

Superior traction for sports floors.

Easy clean up with water.

Tech Specs
Color (dried) Clear
Coverage 700 - 800 square feet/gallon
Dry time 3 - 6 hours minimum
Flash Point None
Pot life 12 hours
Recoat time 12 hours
Rubber burn resistance Excellent
Shelf life 1 year
Solids <34%
Viscosity 30 centipoise
VOC's <350 g/L
Weight per gallon 8.69lbs.
Directions for Use

PREPARATION: FOR NEW OR SANDED FLOORS: Prepare the floor using accepted NWFA or MFMA procedures. Vacuum all dust and tack with cotton towel. All residue must be removed. Apply water-based wood sealer following instructions on sealer label: 2 coats minimum.

FOR SCREENING AND RECOATING: Always clean the floor prior to screening. Mix Betco GT Cleaner at 32 oz./gal. or 250 mL/L (1:4) with water and tack using a clean towel. Screen using new 100 or 120 grit screens or higher, vacuum and tack using a water moistened cotton towel.

APPLICATION: While stirring product, add catalyst slowly and continue mixing for 30 seconds. Mix thoroughly and let stand for 10 minutes. Once catalyzed, pot life is 12 hours. Apply at 600 - 700 sq.ft./gal. Pour finish into a clean, dry, plastic pour can. Pour a 4-inch wide line of finish along one wall with the grain of the wood. With applicator at a slight angle, move the puddle line to the opposite wall, always maintaining a wet edge. At the end of each pass, make a smooth turn with the applicator and squeeze out excess finish with the grain next to the puddle line. Allow to dry thoroughly (minimum 3 hours between coats depending on conditions with a maximum of 24 hours). Abrade between coats if 24 hours has elapsed with a maroon top scrub pad or 120 grit screen. Apply 2 coats minimum. Allow light traffic after 24 hours, however, it is susceptible to scuffing and marring.

Please recycle empty containers. NOTE: Allow adequate ventilation. Circulate air above the floor. Allow adequate airflow for at least 24 hours after final coat is applied. Use air conditioners and exhaust fans where available. NOTE: Slip resistance meets or exceeds (ASTM D 2047-11) James Machine 0.5 minimum.

Similar Products