Green Earth® Prelude™ Floor Finish and Sealer

Non-Zinc Floor Finish and Sealer

This versatile and durable sealer and finish can be used with all types of maintenance programs including both low and high speed. This product is part of Betco’s Green Earth® program. Betco’s Green Earth® products are formulated and packaged to have a reduced environmental impact while still maintaining superior performance. Please dispose of this product and waste generated from this product in accordance with all applicable local, state, and Federal regulations


Use as a sealer or a finish.

High gloss.

Extended wear formula.

0.0% Free Styrene

Tech Specs
Color (dried) Crystal Clear
Color (liquid) White
Coverage 2000 - 3000 square feet/gallon
Drying time 30 - 40 minutes per coat
Fragrance Mild
Freeze/thaw stability 3 cycles
Gloss (ASTM D1455) One Coat 80 -85
Gloss (ASTM D1455) Five Coats 90 -95
Heel mark resistance Very good
Leveling Excellent
pH 7.0 - 8.5
Powdering resistance Excellent
Warranty 2 years
Specific gravity 1.03
Directions for Use

Recommended for use on all types of resilient tile flooring and properly prepared hard surfaces.

RESTORATIVE MAINTENANCE: Completely remove all old wax, finish and soil from floor surface following strip procedure instructions on Green Seal™ certified stripper label. Floor surface must be clean, dry and free of residue before finish is applied. Rinse with clean water if necessary. Apply finish in uniform, thin to medium coats using a clean synthetic finish mop or applicator system. Allow each coat to dry thoroughly before applying additional coats, usually 30 - 40 minutes. 4 - 5 coats of finish are recommended. Note: This product is a self sealing finish, however, if tile is old, worn or porous, initially applying 1 - 2 coats of a sealer will enhance gloss and long term performance.

ROUTINE MAINTENANCE: Damp mop or automatic scrub using a neutral pH cleaner. Buff or burnish the floor as desired. The use of a cleaner/restorer is recommended to condition the floor and extend the time between top scrub and recoating.

INTERIM MAINTENANCE: Top scrub the floor using a top scrub cleaner and recommended floor pad to remove the top soiled layers of finish. Floor surface must be clean, dry and free of residue before finish is applied. Apply 1 - 2 coats of finish as directed above.

Note: Slip resistance meets or exceeds (ASTM D 2047-04) James Machine 0.5 minimum.

Similar Products