Betco® One Coat Wood Floor Finish

Urethane Gloss Finish for Wood Gym Floors

Betco ONE COAT is designed for maximum film build in a one coat procedure. It saves labor time and materials by achieving a deep shine with a single coat. Formulated with excellent leveling properties for easy application that enhances the natural beauty of wood. Less than 450 grams/liter VOC. The perfect finish for a screen and recoat application.

Features

Excellent flow and leveling.

Extended protection and durability.

High gloss/high solids

One coat application.

Tech Specs
Color Light amber
Coverage 400-450 sq. ft/gal
Dry time 18-24 hrs.
Warranty 1 year
VOC Less than 450 grams/liter
Solids 50% +/-
Directions for Use

Recommended for use in finishing all types of wood floors (gymnasium, sports floors, maple and oak).

FOR NEW OR SANDED FLOORS:
NOTE: Always use a respirator when applying this product.
1. Sand the floor using accepted NWFA or MFMA procedures. All old finish must be removed.
2. Finish sanding with 100 or 120 grit screens.
3. Vacuum all dust and tack the floor with dry cotton towels. Repeat tacking if necessary.
4. Apply 2 coats of a penetrating sealer. Follow recommended application procedures for penetrating sealer.
5. Screen seal coat(s) with 120 grit screens, vacuum and tack with waterless cleaner. Let tack dry 30 - 60 minutes with good ventilation before applying paint or finish.
6. Apply finish. Use a lambs wool applicator first across the grain and then with the grain or use a gravity feed applicator applying the product with the grain of the wood.
7. Two coats of finish are recommended. Apply at 400 - 450 sq.ft./gal.
8. Allow to dry at least 12 hours before recoating. Abrade between coats with maroon top scrub pad or used screens.
9. Let dry at least 72 hours before allowing normal traffic.
10. All paints should be tested prior to use for compatibility and adhesion.

PREVIOUSLY SEALED OR FINISHED FLOORS:
1. Tack floor using cotton towels and waterless cleaner.
2. Screen with 100 grit screens with the grain of the wood.
3. Vacuum all dust and tack the floor with cotton towels and waterless cleaner. Repeat tacking if necessary. Let tack dry before coating.
4. Apply with lambs wool applicator first across the grain and then with the grain or use a gravity feed applicator applying the product with the grain of the wood.
5. Two coats of finish are recommended. Apply at 400 - 450 sq.ft./gal.
6. Allow to dry at least 12 hours before recoating. Abrade between coats with a maroon top scrub pad or used screen.
7. Let dry at least 72 hours before allowing normal traffic.
8. All paints should be tested prior to use for compatibility and adhesion.

NOTE: Do not use on resilient tile. Use waterless cleaner for clean up. Not recommended for floors that have been previously maintained with wax or oil.

Similar Products